How do I fix error code P2138?

How do I fix error code P2138?

What repairs can fix the P2138 code?

1. Replacing the throttle body motor or throttle body assembly.
2. Repairing or replacing wiring that is associated with the throttle body motor.
3. Replacing the throttle position sensor.
4. Repairing or replacing wiring that is associated with the throttle position sensor.

Can you drive with P2138 code?

Error Code P2138 is a serious problem, as sudden stalling while driving can be dangerous, especially for heavy traffic or turning.

How do you reset the accelerator pedal position sensor?

To recalibrate the ECM and accelerator pedal, the ignition switch must be in the ON position and then the accelerator pedal must be slowly and fully depressed from idle to full throttle. Repeat the procedure three times.

What is code P2138 mean?

Throttle/Pedal Position Sensor/
Diagnostic trouble code (DTC) P2138 stands for “Throttle/Pedal Position Sensor/Switch D/E Voltage Correlation.” It is triggered when the vehicle’s engine control module (ECM) or powertrain control module (PCM) detects that the signals from the two throttle position sensors (or two accelerator pedal position sensors) do …

How much does it cost to fix TPS?

The average replacement cost for the throttle position sensor is anywhere from $110 to $200. The parts cost is anywhere from $75 to $105 while the labor cost is anywhere from $35 to $95.

What does P2138 mean?

How do I know if my pedal position sensor is bad?

Bad Accelerator Pedal Position Sensor Symptoms

1. Your car hesitates to move when the gas pedal is pressed.
2. Rough Idle.
3. Your car doesn’t accelerate over a specific limit.
4. Your car won’t shift up or jerks upon depressing the pedal.
5. You experience low gas mileage.
6. Check Engine Light.

Where is the accelerator sensor located?

The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle.