How do I access ASUS ROG boot menu?

How do I access ASUS ROG boot menu?

To change boot settings:

1. Enter the BIOS setup menu by pressing and holding F2 key when powering on.
2. Switch to “Boot” and set “Launch CSM” to Enabled.
3. Switch to “Security” and set “Secure Boot Control” to Disabled.
4. Press F10 to save and exit.
5. Press and hold ESC key to launch boot menu when the Unit restarts.

How do you enter bios in TUF gaming?

To enter BIOS Setup after POST: • Press ++ simultaneously. Press the reset button on the system chassis. Press the power button to turn the system off then back on. Do this option only if you failed to enter BIOS Setup using the first two options.

Which key to enter BIOS?

Get ready to act quickly: You need to start the computer and press a key on the keyboard before the BIOS hands over control to Windows. You have only a few seconds to perform this step. On this PC, you’d press F2 to enter the BIOS setup menu.

How do I enable TPM in ASUS BIOS?

1. Press “Del” when the ASUS or ROG logo appears to enter the BIOS.
2. Go to Advanced\AMD fTPM configuration page and switch “TPM Device Selection” option to “Firmware TPM”.
3. Press F10 to save changes & reboot.

How do I enable CSM in ASUS BIOS?

This option is usually in either the Security tab, the Boot tab, or the Authentication tab. Look for a setting called “Boot Mode”, “UEFI Boot”, “Launch CSM” or whatever else it may be called, change the boot mode from UEFI to Legacy/CSM: disable the UEFI Boot option and enable CSM Boot support.

How do I get to the boot menu on my ASUS TUF laptop?

After entering the BIOS configuration, press Hotkey[F8] or use the cursor to click [Boot Menu] that the screen displayed①. Select USB flash drive/CD-ROM in Boot Menu that you want to use②, then press Enter key to boot the system from USB flash drive/CD-ROM.

How do I set my ASUS BIOS to boot priority?

Therefore, the correct order is:

1. Enter the BIOS setup menu by pressing and holding the F2 key, when powering on.
2. Switch to “Security” and set “Secure Boot Control” to Disabled.
3. Switch to “Boot” and set “Launch CSM” to Enabled.
4. Press F10 to save and exit.
5. Press and hold ESC key to launch boot menu when the Unit restarts.