How do I reset my Avaya phone to factory settings?

How do I reset my Avaya phone to factory settings?

Reverting the phone to its original settings

1. Press the Menu button and navigate to the “Administration …” menu.
2. Select and insert the Admin password (default is – 27238).
3. Scroll down the menu and select Clear.
4. Press Clear again to confirm the action. The phone settings are cleared and the phone will restart.

How do I factory reset my Avaya 5610SW phone?

How to Reset and Clear Avaya 5610SW IP Phone Settings

1. Press the * key when your phone is booting up to program it.
2. Press the # key multiple times to skip through all the defaults until you get to the screen that says “Enter Command.”
3. Press the HOLD key and then type RESET #
4. Press the # key to confirm the reset.

How do I reset my Avaya 1616?

Press the Mute key followed with 25327# Then clear all settings by pressing the # (POUND) on the dial then dial # (POUND) again and the phone will reboot to factory default.

How do I factory reset my Avaya j169?

Press the softkey corresponding to Select, or press the line key adjacent to Administration. Enter the default pasword of 2 7 2 3 8 [C R A F T], and press the softkey corresponding to Enter, or press the OK button in the center of the navigation cluster. Scroll down until Reset to defaults is seen and highlighted.

How to reset the power to the avaya-4610 IP telephone?

To reset the power to the avaya-4610 IP telephone, unplug the phone then plug it back in. Press [*] asterisk (sounds a confirmation tone) to reset the phone without resetting any assigned values. Use the given options only if the phone has programmed static values.

How do I Reset my Avaya 9608 to default settings?

Reset Avaya 9608 Reboot the phone.Press the * button to program when it prompts as the phone is starting up.Press mute, then type in 27238 # (CRAFT).A menu will appear, scroll down to Clear and press Start.The display will show “Press Clear again to confirm” Was this post helpful?

How do I reset 1120 and 1140 IP sets to factory settings?

On the 1120 and 1140 IP sets, you can reset them to the factory settings by entering the following on the phone: where is the MAC address of the set which is usually found on a label on the bottom of the set. The default admin password on the 1120 and 1140 sets is: 26567*738 (color*set)