How do I reset my cooler controller?

How do I reset my cooler controller?

POWER OUTAGES & RESETTING COOLER CONTROLLER To reset unit, push reset button using supplied tool (or equivalent). See Figure. If unit responds properly, then change SPT as desired. Also, after a power outage, temperature calibration and time of Pre-Start Mode will revert to factory default settings.

How do I reset my dial thermostat?

Here are the step-by-step reset instructions:

1. Turn your thermostat off by switching it to the off position.
2. Find the breaker that powers your HVAC system and turn it off.
3. Wait 30 seconds and turn the breaker back on.
4. Turn your thermostat back on.

Can a swamp cooler switch go bad?

Also, a bad switch in the swamp cooler motor or fuse can cause the motor to get hot and shut off. Make sure that all connections, switches and wires are correctly installed and maintained to avoid the swamp cooler motor from overheating.

Can you control a swamp cooler with a thermostat?

A thermostat control can be installed on an evaporative cooler to make the operation of the cooler more efficient by turning off the cooler automatically when the air reaches a desired temperature. A thermostat control turns off the evaporative cooler automatically.

How does a thermostat work on a swamp cooler?

A digital thermostat lets you to set the temperature where you want it. Then the swamp cooler automatically runs until it reaches the desired temperature. You have to choose whether you want the fan setting on high or low, but will automatically run the fan until it reaches that temperature.

Why did my swamp cooler stopped working?

Faulty Wiring But if the cooler is still not working, then you should consider further troubleshooting. If your area has constant power surges, then the issue may be a little more complex than a tripped circuit breaker. To check this: Look for the wires that lead to the breaker and the fuse.

Is dial a manufacturer of coolers?

Disclaimer: Dial Manufacturing, Inc. is an independent manufacturer of replacement parts and accessories for evaporative coolers and is not affiliated with any cooler manufacturer. Dial Manufacturing, Inc. is not a licensee of, associated with, or sponsored by any of the original equipment manufacturers.

How do I contact dial manufacturing?

Tel: (602) 278-1100| 1-800-350-3425FAX: (602) 278-1991| 1-800-370-3299 Terms & ConditionsCopyright © 2020 Dial Manufacturing, Inc. All Rights Reserved. Disclaimer: Dial Manufacturing, Inc. is an independent manufacturer of replacement parts and accessories for evaporative coolers and is not affiliated with any cooler manufacturer.

What are the instructions for cooler controller™?

Cooler Controller™ Instructions 1. Cooler Controller is warranted under normal use for 90 days from date of sale to user. In event of defect or failure, replacement is made through your authorized dealer or retailer. 2. Reason for replacement, purchase date, failure date, and sales receipt must accompany Cooler Controller returned for replacement.

What do you need to know about a 7617 cooler controller?

INSTRUCTIONS– COOLER CONTROLLER Model 7617 WARNING: House Voltage can be lethal. Turn off power before installing Cooler Controller. The installer must be technically qualified for this type of installation. A qualified electrician should check all wiring and circuit breakers and be sure that the cooler is correctly grounded.