How do I reset my Napco keypad?
Trouble Display on keypad: Press reset to clear trouble. If this does not work, enter your code and press the function key until the reset menu comes up. Press the ON/OFF key. When “reset system trouble” appears, press ON/OFF again, and then press the RESET key until screen is normal.
How do I turn off my Napco Alarm?
To disarm all areas simultaneously, press 0, G and enter your code followed by J. If any zone is not secured, the keypad will alternately display “CAN’T ARM / AREA #”, where “#” identifies the number of the area(s) in trouble.
How do you bypass a Magnum alert?
BYPASS: Press the B/A key then the 2 digit zone number to be bypassed. CHIME: Hold 5 until keypad beeps. TO ARM SYSTEM WHEN LEAVING: Enter code and leave.
How do you address a Napco keypad?
Press 1 1 1 2 3 MENU (or FUNCTION) to enter the Keypad Configuration Mode option menu. Press STAY (or INTERIOR) repeatedly until the display reads “Keypad Address”. The two-digit number in the display is the current Keypad Address number.
How do you remove a Napco keypad from the wall?
A keypad should be located near an exit/entry door. To remove the keypad from the backplate, insert a small screwdriver into the slots at the bottom of the keypad. Pull up on the screwdriver to pop off the cover.
How do you bypass a Gemini alarm?
To Bypass a zone: Press the bypass button and then enter the zone number. Example: To bypass zone 2 press the bypass button and then 02. Interior Normally Bypassed: System has been programmed to automatically bypass motion detectors. To Remove Bypass: Arm then Disarm the system.
How do I stop my Gemini alarm from beeping?
On the Napco and Gemini keypads, you can press the FUNCTION key until it says “display system trouble” then press the on/off key. On the Magnum Alert keypads, holding down the #9 key for a few seconds will stop the beeping. The beeping will return if the trouble is not repaired.
How do you silence a Gemini alarm system?
Silencing an Alarm To silence the system, enter your User code followed by 1. The keypad sounder and siren will silence, but the zone in alarm will continue to flash. Press 0 to reset this alarm memory.