How do I reset my Smeg dishwasher?

How do I reset my Smeg dishwasher?

Reset your Smeg dishwasher to have it working again as soon as possible.

1. Open the dishwasher door and quickly close it.
2. Locate the “On/Off” button on the left side of the dishwasher control panel.
3. Select and run a dishwashing cycle to ensure that the dishwasher control board has been reset successfully.

Why is my Smeg dishwasher flashing?

The light flashes to indicate that the appliance is in “water hardness adjustment” mode. SALT WARNIN LIGHT (on some models only) If the symbol is present, illumination of this light denotes a regenerating salt warning level.

Where is the anti flood device on a dishwasher?

2 — Use a screwdriver to remove the screws that hold the lower cover in place on the base of your dishwasher. It’s a little awkward but doable. You can see the water and also towards the back you can see the anti-flood device activation switch. It’s the white polystyrene float that’s in the water.

Why is my Smeg dishwasher not starting?

The Basics. A Smeg dishwasher not starting could simply be a problem with the power supply – the appliance won’t start if water is unable to be drawn from the mains water supply. And then the dishwasher should verify the setup and start of a wash cycle. If this isn’t happening the power outlet itself may be at fault.

How do you set up a Smeg dishwasher?

STARTING THE PROGRAM To start the dishwasher, press the START/PAUSE button (6) for a few seconds, until the light of the selected program starts to flash (confirmation beep). The light will flash as long as the program is in progress, to indicate that it is being performed.

Why is my Smeg dishwasher not working?

The Basics A Smeg dishwasher not starting could simply be a problem with the power supply – the appliance won’t start if water is unable to be drawn from the mains water supply. And then the dishwasher should verify the setup and start of a wash cycle. If this isn’t happening the power outlet itself may be at fault.

Why is my Smeg dishwasher not getting water?

Your dishwasher may not be filling with water simply because the water valve’s filter screens are dirty and debris-filled. Gain access to your water inlet valve and try cleaning it out. This might be enough to solve the problem. Alternatively, your water inlet valve could be defective altogether.

How do you fix a flooded dishwasher?

How to Fix a Flooded Dishwasher

1. Mop up the water from the bottom of the dishwasher using rags and a bucket.
2. Check the pump, which is in the bottom of the dishwasher, for large objects obstructing drainage.
3. Check the kitchen sink drain and garbage disposal for clogs.
4. Run the disposal to clear it if this is the problem.

How does a dishwasher flood switch work?

The water that fills your dishwasher lifts the float, and when it reaches a certain level, it acts as a trigger for the float switch. The float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.

Who makes Smeg dishwashers?

Bertazzoni family
The first Smeg dishwashers were produced in the 1960s, leading to the development of 60cm wide 14 place setting dishwashers which remain the standard today. Smeg is still based in its founding village and continues to be run by the Bertazzoni family.