How do I reset my Uniden Bearcat BC125AT?

How do I reset my Uniden Bearcat BC125AT?

With the scanner off, hold down the HOLD, 2, 9 keys while powering up the scanner. This will reset your scanner back to the factory default and you WILL have to reprogram all of your channels and banks.

How do I setup my Uniden Bearcat scanner?

Programming a Handheld Model of the Uniden Bearcat Scanner

1. Ensure the battery is fully charged, or plug in the AC adapter.
2. Press the “Scan” button to put the handheld into scanning mode and press “Manual” to enter manual programming mode.
3. Enter the frequency you wish to store, using the numeric keypad.

Is the BC125AT digital?

There is no 800 MHz coverage on this scanner. There is also no trunking or digital modes receive on this scanner. It is known as a conventional, analog radio scanner. The Uniden BC125AT is a bank/channel type scanner.

How do I update my BC125AT?

Scanner 101 – Installing New Firmware for the BC125AT

1. Firmware Update.
2. Download the Firmware loader for the BC125AT – Download here.
3. When download prompt pops up select “Open”
4. A window will pop up select BC_VUP_V3_00_01 folder.
5. Select Setup_BC_VUP.msi and then click run.
6. Click close on the Installation Complete window.

What is the best aircraft scanner?

What is the Best Aviation Scanner? Military & Civilian – We recommend the Uniden SDS100. Civilian only – We recommend the Uniden SR30C. There are a lot of aviation scanners on the market and—like most electronics—you get what you pay for.

What is a trunking scanner?

Since a trunking system might send its call and response on different frequencies, a “Trunking” or “Trunk-tracking” scanner is needed. These scanners will let you monitor the control channel frequency as part of the TalkGroup so you can hear both calls and responses and more easily follow conversations.

How to program Bearcat scanner?

Turn the “Volume” knob to the right to turn the scanner on.

Press the “Manual” button on the control panel of the device.

Enter the frequency for the first emergency station you want to save.

Repeat Steps 2 and 3 for each frequency you want to save.

How do you program a scanner?

Add frequencies to your scanner. Press “Manual” and enter the channel where you want to store the frequency. Press “Program” and enter the frequency on the keypad. Press “WX/E” to save the setting. Search for frequencies with the limited-search feature. Press the “Program” button, then “Limit.”.

How to program a police scanner?

Open EZ Scan software on your PC computer.

Connect your scanner and computer.

Within EZ Scan click Scanner/SD card.

Select Copy Configuration from Scanner Memory/SD card. Note it is faster utilizing just the SD card.

Select which drive your Scanner or SD card is located.

Select continue until you are on EZ Scan software.

Select File.

Scroll down and select Save Current Configuration to Archive.

Decide which drive and folder you want this to live on your computer.

You now have a copy on you computer you can access in the future by selecting File and Restore Configuration From Archive.

How do you program a police scanner?

Programming a Base Model Read the manufacturer’s information. Find frequencies. Connect the antenna and plug in the scanner. Locate the programming button. Press the programming button. Insert the channel number. Enter one of your frequency numbers. Press “Enter.”.