How do you hook up a HPS ballast?

How do you hook up a HPS ballast?

To connect the ballast to the socket, get the white wire from the socket, locate the com2 or comX2 on both the short side of the transformer and the igniter and connect the three together using a wire nut. Locate the wire labeled lamp on the long side of the transformer and the X1 wire on the ignitor.

Which wire is hot on a ballast?

black
Generally, the hot wire on the ballast is black, and the neutral is white. The other colors are the wires that connect the ballast to the fluorescent tube holders and to each other.

How do you troubleshoot HPS lights?

Troubleshooting High Pressure Sodium Lights

1. The Bulb. The most common problem with a high pressure sodium light is the bulb.
2. Wiring. Check all wiring for any signs of loose connections or burned wires.
3. Ballast and Capacitor. Test the input voltage and output voltage of the ballast transformer.

Can one ballast power two bulbs?

The two bulbs will always have slightly different impedances, so more current will flow through one or the other. It’s difficult to balance this out. The condition where one bulb is fired and the other is not is obviously the worst case for this.

What are yellow wires for on ballast?

The common yellow wires connect from the ballast to push-in connectors on one of the right holders of lamp 1 or 2. Two yellow wires connect the common lampholders together.

What is the full form of HPMV lamp?

High Pressure Mercury Vapour Lamp (HPMVL)is a high intensity discharge lamp in which the major portion of the light is produced by radiation from mercury operating at a partial pressure in excess of 100 kPa.

What size wire do I need for an HPS ballast?

When purchasing individually, make sure to buy the correct rating for the home, usually 120V in most homes. In addition to these three, the HPS ballast should also be wired to a bulb and socket; therefore, there is a need for a 14 gauge wire, wire nuts, power cord, and male plug set.

How do you connect a ballast to an ignitor wire?

Connect this wire to the ignitor wire marked X3 or 3 as well. Be certain no bare wire is exposed. To connect the ballast to the socket, get the white wire from the socket, locate the com2 or comX2 on both the short side of the transformer and the igniter and connect the three together using a wire nut.

How do you connect a ballast to a transformer?

Connect the com wire to the white wire on the power cord and the 120 wire to the black wire. Make sure all connections are secured using wire nuts. Afterwards, connect the bare wire to the base of the transformer or to the enclosure. Install the enclosure to cover the ballast and tighten the screws.

What is a high pressure sodium (HPS) ballast?

A high pressure sodium (HPS) ballast is used in conjunction with an HPS grow light. The ballast is responsible for igniting the gas in the tube, which creates the light. At this point, the ballast regulates this current, ensuring the charge does not exceed a safe level. Without a ballast, the light will burn to hot and pop.