How do you reset the tire pressure sensor on a 2011 Camaro?
2010-2011 Models
- Turn the ignition key to the “ON” position without starting the engine.
- Press the MENU button repeatedly until you see the VEHICLE INFORMATION menu on the display.
- Scroll down to the “TIRE PRESSURE” menu.
- Press and hold the SET button to enter the relearn mode.
- Activate the TPMS sensor.
What should my tire pressure be?
On newer cars, the recommended tire pressure is most commonly listed on a sticker inside the driver’s door. If there’s no sticker on the door, you can usually find the specs in the owner’s manual. Most passenger cars will recommend 32 psi to 35 psi in the tires when they’re cold.
Why is my tire pressure light on after new tires?
If your tire pressure light stays on even after you’ve added the correct amount of air to the tires, you’ll need to reset it. If your TPMS light remains on after inflating the tires to the proper pressure, try these steps: Drive the car at 50 mph for about 10 minutes.
What should the tire pressure be on a Camaro?
The good news is that it has this tire pressure readout on its instrument cluster. Actually its very good news since it’s raining today and checking the tire pressures old school would not have been fun. The bad news is that all four of the Camaro’s 20-inch Pirellis is low. Spec is 36 psi cold.
How do you reset the tire pressure light on a Camaro?
Turn the ignition switch to the ON position (engine off) and lower the driver side window. Press and release the trip odometer button to scroll to the Tire Pressure display. Hold down the trip odometer button for five seconds then press the button again to confirm.
How long does it take for the tire pressure light to go off?
How long does it take for the tire pressure light to go off? After your tires are properly inflated, the sensor light usually goes off after you’ve driven a few miles. However, if it doesn’t turn off on its own after about 10 miles, you should reset the TPMS as per the instructions in the owner’s manual.