How do you set the time on a SkyScan atomic clock?

How do you set the time on a SkyScan atomic clock?

1. Press SET 1 time: Time Zone: The time zone will flash in the date display.
2. Press SET 2 times: Daylight Savings (DST): The time will change to ON or OFF.
3. Press SET 3 times: Language: The time will change to a letter.
4. Press SET 4 times: Hour will flash: Press the plus (+) button to change the hour.

How do I reset SkyScan temp transmitter?

To reconnect them you must first take the batteries out of both of the units for 15 minutes. First put the batteries back into the transmitter, and then the clock. Let them sit side by side inside your home.

Why choose skyscan atomic clocks®?

Skyscan Atomic Clocks®, are engineered to meet tough environmental and industry demands while maintaining their trademark simplicity and user-friendly interfaces.

How does the US atomic clock work?

Using a low frequency radio transmission from NIST, the US Atomic Clock sends an accurate time signal across the continental United States. The SkyScan® Atomic Clock automatically sets itself to the correct time and date by receiving and decoding the NIST radio signal with an internal receiver.

How long does it take for the clock to set up?

Please allow 24 hours for the clock to pick up the signal up and set itself. It is best to set your clock up at night. The signal is strongest between 12 and 6 am. Put the clock in a window overnight until the clock sets. If you remove batteries from the transmitter you must also remove the batteries from the clock.

How do I reset the clock on my Clock transmitter?

Put the clock in a window overnight until the clock sets. If you remove batteries from the transmitter you must also remove the batteries from the clock. See the reset procedure inside. Put the transmitter in a dry shaded area away from the sun and direct rain.