How far down should a star nut be?

How far down should a star nut be?

Star Nut Installation with TNS-1 The TNS places the nut about 15mm (9/16″) below the top of the steering column. This allows the adjusting bolt to thread fully into the nut for adjustment pre-load. It can also help maintain alignment to use the stem as an alignment guide.

Can I reuse a star nut?

Have you got a star nut for the top of the fork.? You can reuse the old one if the steerer tube is the same diameter all the way down which will allow you to knock the old one all the way through. To fit the star nut, screw in a bolt and tap the star nut down into the fork by a about CM.

Can I reuse Starnut?

Can you reuse a star nut?

Does Fork come with star nut?

Typically forks do not come with a star nut. New headsets do, though. Your LBS should have a new star nut for you to shove in there. America eats its young.

How do you install the StarStar steering column nut?

Star Nut Installation with TNS-1. Mount the nut with concave side toward tool thread. Hold TNS over steering column and tap on top on TNS with ball peen hammer. Hold tool aligned while striking TNS. The TNS places the nut about 15mm (9/16″) below the top of the steering column.

How to fix a loose nut on a tube?

Once the nut reaches the maximum depth that the tool allows, check that the tool is straight and flush to the tube. If it isn’t, a few more light taps should help the tool automatically correct this.

Where does the TNS nut go on a steering column?

The TNS places the nut about 15mm (9/16″) below the top of the steering column. This allows the adjusting bolt to thread fully into the nut for adjustment pre-load. It can also help maintain alignment to use the stem as an alignment guide.

Is it necessary to completely remove the nut from the column?

It is not necessary to completely remove the old nut. It is also possible to drive the old nut completely through the column and out the bottom. This will make the nut unusable.