How to make wire wrapped jewelry?

– Cut the Wire. Cut two pieces of 24-gauge wire each at least 5 inches long. The exact amount of wire will depend on the size of your stone. – Twist the Wires Together for 1 Side. At their center points, cross the two wires and twist them together (as shown in the photo below). – Align the Wire on the Stone. Hold the section of twisted wire along the side of the stone, and place the stone between the two wires (as shown in the – Twist the Wire to Form the Basket Base. Twist the wire on the other side of the stone just enough to secure it. – Finish the Wire Twists for the Other Side. Finish twisting the wire until this side is the same length as the other side (or an appropriate length to line up – Secure the Stone. Holding the stone in place, take one wire from each side and bend each pair together in the front and the back. – Twist the Wires Together. Twist the pairs of wires together on the front and the back to secure the stone. Twist up at least an inch with each pair. – Secure the Wires. Bend one of the twisted wires at roughly a 90-degree angle, and wrap it around the other twisted wires at least two times. – Trim the Ends. Trim the end of the wire you just twisted in a spot on the side or back of the pendant, so it will be out of sight. – Make a Wrapped Loop. Use your round nose pliers to form the loop for the top of the pendant. – Adjust the Wires and Add a Chain

How to create a wire art necklace?

Prepare the board. Sand and stain the board in the color of your choice.

Draw the shape. Draw the shape you want to create.

Make the holes. Using the 1/16″ drill bit,make holes all along the shape.

Thread wire through the shaft. Cut a decently long length of wire – 4-5′.

Make the Vane.

Add something unexpected.

How to make a wire wrapped gemstone jewelry set?

Make your final binding at the top of your design.

Seat your centerpiece in your wire wrap design. Use pliers to bend the front and back Vs so as to form a secure seating in which the centerpiece sits.

Cut off excess wire.

Bend one or two wires at the top of your design to make a loop.

How to make wire bracelets?

In cursive,write down your desired word. Make sure all the letters connect to each other.

Use the word you’re written down as a guide when wrapping the wire to “write” the word down.

Cut with your wire cutters. Make sure to leave approximately an inch of wire on both ends.

Use your round nose pliers to create a loop using the extra 1″ of wire.

Insert the leather straps through the loop you just created.

Secure the strap by wrapping a wire around it 1-3 times,then cut the excess leather strap to size.

You can measure the leather strap exactly to the circumference of your wrist before attaching the clasp at the end.

You can also create a wrap bracelet by increasing the length of the strap so it goes once or twice around your wrist.