How wide are Dana 60?
Dana 60 Specs
| Years Produced: | 1955 – current |
|---|---|
| GAWR: | up to 6,500 lbs |
| Overall Width: | 69.339″ flange to flange |
| Ring Gear: | 9.75″ |
| Axle Spline Count: | 16, 23, 30, 32, 35 spline (35 most common) |
What is the diameter of a Dana 60 axle?
3.125 inches
The Dana 60 only came with one axle diameter of 3.125 inches, which is pretty big. Those larger axle tubes help strengthen the housing, but also make room for larger axle shafts.
Are all Dana 60s the same?
There are three major variations of the Dana 60 axle used in the 1960s to 1980s. GMC, Chevy, and Jeep are all basically the same. There are three major variations of the Dana 60 axle used in the 1960s, 70s, and 80s: Dana 60 axles on the GMC, Chevy, and Jeep are all basically the same.
Is a Dana 60 a 1 ton axle?
Tip: Saying You Have A “1 Ton Axle” Doesn’t Say Much. One thing that’s confusing about the Dana 60 axles is that a Dana 60 in front is usually considered a 1 ton axle, and a Dana 60 in the rear is usually considered a 3/4 ton axle.
How wide is a Dana 60 front end?
The front Dana 60 inner axle shafts are 1.5″ in diameter and have 35 splines. The u-joints are considerably stronger than those in the D44 and the outer stub shafts can be upgraded to 1.5″, 35-spline shafts.
What size ring gear does a Dana 60 have?
9.75 inches
The Dana 60’s ring gear is 9.75 inches in diameter, and the available gear spread ranges from 3.31:1 to 7.17:1.
Is a Dana 60 limited slip?
The passenger car version of the Dana 60 came equipped with the Mopar “Powr-Lok” semi-float limited-slip differential option from 1966 to ’69. The Powr-Lok differential used 30-spline axles. The axle bearings, seals and retainer packages are interchangeable.
How much horsepower can a Dana 60 handle?
Additionally, the Dana 60 (S60) from Strange comes equipped with their beefy 35-spline alloy axles and carrier that can handle over 1,000 horsepower. A vintage Dana 60 like ours with its stock 23-spline axles and clutch-type Sure-Grip is limited to roughly 700 horsepower of sticky tire, strip action.
How much power can a Dana 60 handle?
What car uses a Dana 60 front axle?
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
How can I tell what is a Dana 60?
Specifications. The Dana 60 was made in a full-floating and semi-floating configuration. The Dana 60 usually has a 30-spline axle shaft.
What is a Dana 60 axle?
The Dana 60 front axle is a heavy-duty 4wd front steering axle manufactured by Dana Spicer corporation. It was most commonly used in many one ton and some 3/4 ton pickup trucks.