Is a kickdown cable necessary?

Is a kickdown cable necessary?

In fact, if you don’t mind downshifting manually with the shift lever when passing, there’s really no need for a functional kickdown cable or switch at all. You must install a true TV cable with the correct throttle-lever pivot geometry and then adjust it properly or you will burn up the trans!

Can I drive without a kickdown cable?

Shouldn’t be a problem. The cable adjusts system pressure, so shift pressure. With the cable fully retracted it will shift lazy/slip a lot, if the cable was pulled fully out it will shift more firmly, less slip.

Can you adjust a kickdown cable?

Turn the steel shoulder of the kickdown cable with combination pliers. Turn the cable counterclockwise, adjusting until the cable is fully extended with a small amount of slack in it. The slack prevents the cable from breaking when the accelerator pedal is forced to the floor.

How do you adjust a Lokar kickdown cable?

Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench.

What is the purpose of a kickdown cable?

One component that helps both drive systems communicate is the kickdown cable. This device helps the engine relay information on revolutions per minute (RPM) to the automatic transmission and essentially tells it that it’s time to shift gears.

What is a kickdown used for?

Automatic transmissions kick down to a lower gear to make use of the greater power delivered at the engine’s higher rpm; this typically occurs when the driver attempts to accelerate from a constant speed, as if to pass.

What does a kickdown cable do on transmission?

The transmission kick down cable works to shift the transmission to a higher gear automatically when the engine is revved or otherwise accelerated. A kick down cable comes installed standard on any vehicle, but there are also a variety of aftermarket kick down cables that can be purchased as well.

Does a TH400 have a kickdown cable?

Instead of a linkage or cable, the TH400 uses an electrical switch that is most often mounted on the carburetor. The factory used a switch located on the carburetor or on the throttle linkage under the dash that at WOT supplied voltage to the transmission.

How do I know if my kickdown cable is bad?

If you feel that your car’s transmission is shifting roughly, too fast, or too slow, you may need to replace the kickdown cable….Listed below are a few of the warning signs that a problem with the kickdown cable exists.

1. The transmission shifts hard.
2. The car shifts early and fast.
3. The transmission shifts slow and late.