What does F5 mean on a Hotpoint Aqualtis washing machine?

What does F5 mean on a Hotpoint Aqualtis washing machine?

Error code F05 on some Hotpoint (and some Indesit) washing machines means the pressure switch has “jammed” on. So the washing machine thinks it is full of water and refuses to spin.

How do I reset my Aqualtis washing machine?

Aqualtis Demostration Mode To activate hold start/reset and the 4th button (bottom one) for six seconds and “D” will be displayed in the spin speed display. To deactivate, press and hold start/reset as power is applied for three seconds.

How do I fix F05 error on my Whirlpool washer?

Whirlpool error F05 or E2 This means there’s something wrong with the water temperature sensor. Time to reset the Whirlpool. Switch off the washing machine and remove the connector for 30 minutes. Afterwards, plug the washing machine back in and start it up again.

How do you unblock a washing machine waste pipe?

To unclog a clogged drain, first fill a bucket with boiling water and a pack of baking soda. Remove the drain pipe from your washing machine and slowly pour the water into the drain using a funnel. Wait a few minutes and test if it keeps draining if you pour water into it.

What does F18 mean on a washing machine?

Washing machine troubleshooting: error codes E18 or F18 These error codes indicate the pump time has exceeded its limits. Why am I getting this washing machine error code? This could happen for several reasons: blockage inside the filter, blockage inside the draining hose or a problem with the pump.

How do you reset a Whirlpool washing machine?

Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.

How do I fix the F5 on my Whirlpool washer?

Do not force the lid open, as permanent damage could occur. Remove any objects from the lid and clear any obstructions. Touch POWER to exit cycle, then touch POWER again to release lid. If this is unsuccessful, reboot the machine by unplugging the washer and wait two minutes before plugging the machine back in.

https://www.youtube.com/watch?v=zgkvMe24sTY