What is a waling beam?
Waling beams are used in combination with tie bars for anchoring sheet pile walls. They allow to spread the load on sheet pile and to concentrate them onto the tie bars. Waling beams and tie bars therefore form a system with strong compatibility with one another.
What is a whaler in concrete?
The whalers are the horizontal wooden braces connected to the plywood wall form with cow bells. The strongback is the vertical wooden brace, holding the whalers straight and together, and the brace on the floor can be adjusted in and out with the blue turnbuckle.
What is a bridge Waler?
Waler systems are easily-assembled, two-sided hydraulic bracing systems designed to be used with steel trench sheets to horizontally brace small trenches. Waler systems are typically used for the safe installation of utilities, particularly in excavations where services are present.
What is a steel waler?
DESCRIPTION. Walings are designed to transmit all loads from the soil through the retaining wall to the steel tie bars and to align and brace the wall in its position. In many applications, a steel waler or reinforced concrete beam is used to transfer retained loads evenly between tie rod connection points.
What is the function of a waler?
Walers perform two other functions. First, they protect the concrete floating dock from impact from a docking boat. Secondly, they present a gentle surface to the hull of a boat using the moorage, especially when the walers are built of structural timbers and when combined with protective rub rails.
How do you use Waler brackets?
Aluminum waler brackets are designed to be used with a three hole tie at the top of the wall. Simply insert over the three hole tie. This bracket does not require loose pins or wedges. Note: When utilized with the WTF tie, stripping is accomplished by striking downward with a 2″ x 4″ from the top of the wall.
What are Whalers on the dock?
Walers are structural beams mounted flush to the deck of the Unifloat concrete floating dock from Bellingham Marine. They attach to the float by long rods threaded at the ends. Called “through rods,” they span the width of the float and are held in place with washers and nuts.
What is a tieback in construction?
Tiebacks are a horizontal wire or rod that reinforce retaining walls for stability. These tiebacks are anchored on one end to the wall and to a stable structure on the other. This could be a concrete deadman that’s been driven into the ground or anchored into the earth with resistance.
What is a steel Waler?
What is a waler plate?
Waler Plates A high quality pressed plate used in conjunction with the wing nuts to spread the load into the steel or timber soldiers. or. A high quality flat plate used in conjunction with the wing nuts to spread the load into the steel or timber soldiers.
What is a Whaler on a dock?
What are John A brackets?
OCM Jahn-A Bracket – New This Jahn-A Bracket can be utilized to hold a single horizontal wale or a single vertical stud with any type of wall form; round, curved, battered, beam and/or columns. The Jahn-A Bracket can be installed before or after the wales have been positioned.