What is considered a leading edge?
Leading edge: The edge of a floor, roof, or formwork for a floor or other walking or working surface (such as the deck) which changes location as additional floor, roof, decking, or formwork sections are placed, formed, or constructed.
Where should a leading edge be placed?
In the Safety and Health Regulations for Construction, CFR 1926 Subpart R, OSHA defines a leading edge as “the unprotected side and edge of a floor, roof, or formwork for a floor or other walking/working surface (such as deck) which changes location as additional floor, roof, decking or formwork sections are placed.
What is a leading edge application?
A leading-edge application involves anchoring an SRL below the back D-ring of the harness to prevent the wearer from falling over a sharp edge, which is any unrounded edge on the jobsite with the potential to make contact with the SRL. The SRL can be overhead (vertical) or at foot level (horizontal).
What is a leading edge hazard?
One of the most dangerous aspects of working at height are leading edge hazards. This is often construction work that is performed at an unprotected edge, perimeter or border where a fall hazard exists. Increased fall distance because typical anchor point is at foot level.
What is the fifteen leading edges?
These 15 leading edges were: (1) aquaculture and (2) marine fisheries, (3) forestry and (4) natural resources, (5) process industry, (6) food and (7) feed industry, (8) energy, (9) transportation, (10) construction industry, (11) information technology, (12) electronics, (13) instrumentation and control, (14) emerging …
How close can you get to a leading edge?
between 6 feet and 25
As stated in the standard, control lines must be between 6 feet and 25 feet from the leading edge.
How close can you work to a leading edge?
As stated in the standard, control lines must be between 6 feet and 25 feet from the leading edge.
What criteria are used to categorize nations as industrialized?
One such criterion is income per capita; countries with high gross domestic product (GDP) per capita would thus be described as developed countries. Another economic criterion is industrialisation; countries in which the tertiary and quaternary sectors of industry dominate would thus be described as developed.
Is fall protection required on a roof?
As far as OSHA is concerned, there is no safe distance from the edge of a roof, so you must be protected. This means that you must have rails, fall arrest systems, or a warning line/safety monitor setup no matter where it is you are working.
How high can a platform be without handrails?
Specifically, all platforms 4 feet or more above the adjacent floor or ground must be protected by a standard guardrail on all open sides.