What is the OSHA requirement for eyewash stations?

What is the OSHA requirement for eyewash stations?

The OSHA requirements for emergency eyewashes and showers, found at 29 CFR 1910.151(c), specify that “where the eyes or body of any person may be exposed to injurious corrosive materials, suitable facilities for quick drenching or flushing of the eyes and body shall be provided within the work area for immediate …

How do you activate an emergency eyewash?

How to Use an Eyewash Station in an Emergency

1. Activate the unit. Push the activation lever on the eyewash station.
2. Flush out your eyes.
3. Contact lenses.
4. Keep on flushing.
5. After flushing.

How do you use an eye wash station and safety shower?

Teach workers to follow these steps when using an eyewash:

1. Turn it on. Push the handle or otherwise activate the water flow, then let go; the eyewash should stay on until you turn it off.
2. Remove contact lenses if you’re wearing them.
3. Hold your eyes open.
4. Don’t rub.
5. Don’t stop.
6. See a doctor.

How close should an eyewash station be?

55 feet
Eyewash safety stations must be installed within 10 seconds or 55 feet from the hazard. The spray pattern must measure between 33”–53” from the floor the user will stand on (section 5.4. 4).

How often should eyewash stations be inspected OSHA?

Inspect all eyewash units annually for compliance with the ANSI Z358. 1 standard (Section 5.5. 5). Location: The eyewash safety station must be located within 10 seconds, approximately 55 feet, from the hazard.

How do you turn eyewash off?

Once an eyewash station has been activated it cannot be turned off. The eyewash solution will flow until the cartridges or reservoir have been emptied.

How do you change the water in a eyewash station?

How to Refill a Self-Contained Eyewash Station

1. Drain all the water from the tank.
2. If possible, remove the spray heads and any tubing so they can be cleaned.
3. Clean the exterior of the unit, and then use a soft brush, mild soap and warm water to clean the inside.
4. Drain the wash water and rinse thoroughly.

How do you inspect a portable eyewash station?

Testing Your Eyewash Station

1. Check for running water. The valve activates in a second or less and remains open until closed by user.
2. Check for flow. The water stream should be about six inches long, with both streams crossing at the center of the eyewash nozzle.
3. Check for balance.
4. Check for temperature.

How do you turn off emergency eyewash station?