Where is the model number on a Graco double stroller?
Find the model number on the stroller, which can be found on a label at the lower portion of the rear frame, just above the rear wheels or underneath the stroller. You can also find the model number by looking for another label on the metal bar under the front foot rest.
How do you open a Graco 2 in 1 stroller?
Place the stroller on a flat surface with the wheels on the ground and the handle facing upward. Snap the handle into place by pressing the buttons located on the outer side bars of the handle and pulling the handlebar upward until you hear a “click.” Release the side latches on either side of the stroller to open it.
Can you put a car seat in a Graco stroller?
TO PUT CHILDREN IN THE STROLLER: † You may use this stroller with two infant car seats. Refer to the section “To Attach Graco® Infant Car Seat” pages 36-43. Only use a GRACO® SNUGRIDE®CLICK CONNECT™
What do you need to know about the Graco duoglider?
Page 1 DUOGLIDER featuring Owner’s Manual Graco PD349315A 4/16… Page 2 3-G Child’s Tray 3-H Front Canopy 4 Use To Secure Child Swivel Wheels Brakes 4-D To Recline Seats To Fold Stroller Rear Seat Reclined Carriage Position 4-G To Attach Graco® Infant Car Seat to Rear Position 5 Cleaning Care & Maintenance…
Can a SnugRide stroller be used with a car seat?
(Not intended for use with SnugRide®, SnugRide® 30, SnugRide® 32, SnugRide® 35, Infant Safeseat™, AUTOBABY, LOGICO S, JUNIORBABY and ASSURA infant car seats.) Improper use of this stroller with other manufacturers’ car seats may result in serious injury or death. † READ THE MANUALprovided with your Graco car seat before using it with your stroller.
How do you attach a stroller to a car seat?
Position mounting notches over the seat back. Push down on car seat until the attachment latch snaps in place. Page 43 Pull stroller waist straps through vehicle belt hook on both sides of the car seat. Check that infant car seat is securely attached by pulling up on it.