Why is my Poulan Chainsaw not starting?
If your Poulan chain saw won’t start, the first thing to check is the fuel. Then turn the saw on, hold it firmly and pull the start rope in short, brisk pulls until it starts. If it doesn’t start within 15 pulls, the spark plug is likely wet-fouled. Remove it and check for moisture on the electrode.
Where is the spark arrestor on a Poulan Pro chainsaw?
The arrestor is a screen that fits behind the muffler.
Where is the idle screw on a Poulan chainsaw?
To adjust the carburetor idle speed, locate the idle speed screw labeled with a “T” just above the primer bulb.
Why is my Poulan chainsaw flooding?
Does your chainsaw fail to start and you don’t know why? There could be various causes: incorrect fuel mixture, carburation not calibrated properly, or a wet spark plug. Neglecting to look after a chainsaw can lead to malfunctions such as flooding. …
How long will a Poulan Pro chainsaw last?
Re: Poulan Pro Chainsaws To make up for the low price they may have lower quality parts, especially internal engine parts. Most of those discount saws have about 40 hours expected useful life built in to them. Stihl’s, in comparison, are either 500 or 1000, depending on the model.
Can you remove the spark arrestor?
You can safely remove the spark arrestor or even install an aftermarket exhaust system on many ATVs without having to make alterations to your jetting because they are normally set up to run a bit rich from the factory, but this is no general rule!
What is the T screw on a Poulan chainsaw?
The screw on top — marked “T” — is for adjusting the fuel mixture while the engine is idling. Of the two underneath it, the one on the left is for adjusting the mixture when the engine is running a low speed, and the one on the right is for making the same adjustment when the engine is running at high speed.
Why does my Poulan chainsaw not start when hot?
Why Poulan Chainsaw won’t Start when Hot There could be several reasons for this: The spark plug is failing, so there won’t be sufficient spark, especially as the engine is warmed up.
How do I know if my Poulan Saw needs new spark plugs?
If you notice any of these things, get a new spark plug suitable for your Poulan saw. Clean the air filter thoroughly by soaking in hot water and soap and washing clean. If it’s worn out or torn, replace it. If you notice that it sags, replace it at a Poulan service center.
What should I do if my Chainsaw won’t start?
Check that you are not using stale fuel, discard and empty the tank if the gas has spent over 2weeks in the saw. Replace with fresh fuel, using the correct fuel and oil mix. Also, make sure you put in sufficient fuel that will enable the engine to work. If the issue is a blocked carburettor, clean it thoroughly using a carburettor cleaner.