How do I reset my Astro remote starter?

How do I reset my Astro remote starter?

Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.

How do you reprogram AstroStart?

Astrostart Alarm Key Fob Remote Programming Instructions

1. Open you hood. If needed, jump the red/black wire to a good ground.
2. Turn the key on, press and release the brakes.
3. Turn key from on to off 3 times.
4. Push any button the first remote to be programmed.
5. Turn key on and press brakes once.

Does Astro start have an app?

AstroStart® SmartStart To make full use of the powerful AstroStart SmartStart App, you need to have the AstroStart SmartStart hardware and a compatible AstroStart system installed in your car.

How do I change the battery in my AstroStart remote?

Replace AstroStart Remote Start Battery

1. Locate the small gap on the side.
2. Start to pry open the case. The end of the keychain works well for this part.
3. Now you can see the batteries and slip them out.
4. You can now replace the two batteries.
5. Reverse these steps to put the key fob back together, and you’re set.

How to troubleshoot autostart remote not working?

In fact, there are some easy troubleshooting methods to get your AutoStart remote working again in no time. Ensure that you are in close enough range when using your remote start remote. Your remote start user manual should indicate the maximum number of feet at which the remote will function.

How long should I press the remote start button to start?

Press the remote start button long enough to ensure that it is recognized by the receiver in the vehicle. It’s best to hold down the remote start button for at least a full two seconds.

How do I program my remote start to my car?

Ensure that you are holding the remote high enough so that it makes contact with the receiver found in the vehicle. Holding the remote down by your waist may impede range. It is best to hold the remote out in front of you. Press the remote start button long enough to ensure that it is recognized by the receiver in the vehicle.