How do I reset my Webasto Thermo Top C?

How do I reset my Webasto Thermo Top C?

Error Lockout Reset Thermo Top C with “Timer” After correction of the malfunction the error lockout is reset by switching the heater off and on again. In case of overheating an error lockout reset is achieved by removing fuse F1, 20A for at least 10 seconds. The fuse is not blown in case of an overheat condition.

How do you clear a Webasto code?

In order to clear the fault you can do one of two things. With the heater on, remove the main fuse, switch the control panel off, re-insert fuse and switch heater on again, OR contact your local Webasto agent and they can unlock your heater with the PC diagnostics.

How do I run a Webasto diagnostic?

Hardware connection procedure

1. Connect the USB or serial (COM) cable to the correct port on the PC.
2. Connect the USB or serial (COM) cable to the correct port on the diagnostic unit.
3. Connect the adapter to the diagnostic unit.
4. Connect the diagnostic unit to power.
5. Connect the adapter to the heater.
6. Turn the heater on.

How do you clear Espar codes?

To clear fault codes:

1. While in diagnostic mode push and hold both arrow buttons until “EE” is displayed on the screen.
2. To exit diagnostic mode hit the ON / OFF button.
3. To shut the unit down hit the ON / OFF button again.

Can Webasto cool?

Webasto Cool Top unit provides a wide temperature operating range, it can cool your vehicle down to -5C / 23F or heat up to 50C / 122F.

Can a diesel heater be mounted sideways?

Don’t install the pipe horizontally or with the exhaust port facing upwards. If the exhaust port is installer horizontally, the outside wind may blow right into the exhaust port, reaching the combustion chamber through the exhaust pipe.

How do you prime a fuel line?

Priming the Fuel Pump

1. Disconnect the hose that connects the fuel pump to the carburetor.
2. Spray a three second burst of starting fluid into the carburetor.
3. Repeat the spray-and-die procedure until you see fuel begin to wet the rag on the fuel line.
4. Reconnect the fuel line to the carburetor.

What are the fault codes on a Webasto heater?

Webasto heater fault codes (diagnostic trouble codes or flashing codes) with explanations: F00, F01, F02, F03, F04, F05, F06, F07, F08, F09, F10, F11, F12, F13, F14, F15

Where can I find a Webasto thermo top C repair kit?

Alongside our Webasto Thermo Top C manuals, here at Butler Technik, you can find an extensive range of repair parts, replacement pieces and repair kits for your vehicle’s Webasto heater. Discover our full Webasto page to view the full collection.

What does the green light on my Webasto heater mean?

On many models of Webasto heaters, the green operating status light gives a fault indication when the heater is not working. If you have a Webasto timer installed, the fault indication may even be shown in the form of a code (F03 for example).

What does it mean when your Webasto says blow out?

On other Webasto models it refers to a defective overheat sensor/blow out sensor. The usage wiring checks for cable damage and correct insertion of the plug should be checked before replacing the sensor. This fault can be caused by restriction in exhaust air flow or sooting of the sensor.