How do you drain a VX Commodore radiator?

How do you drain a VX Commodore radiator?

Starts here3:02How To – DIY Coolant Flush – Nulon Motorsport Garage – YouTubeYouTubeStart of suggested clipEnd of suggested clip34 second suggested clipCheck the car up if you need to take off the radiator cap being careful of any pressure builderMoreCheck the car up if you need to take off the radiator cap being careful of any pressure builder remove. Either the radiator drain plug or remove the bottom water hose to drain the coolant and flush.

How do you drain a VY Commodore radiator?

Starts here7:11How to Properly Flush Radiator Coolant – YouTubeYouTubeStart of suggested clipEnd of suggested clip55 second suggested clipSo we’re going to have to pull one of the hoses off of the radiator. And drain it that way you’reMoreSo we’re going to have to pull one of the hoses off of the radiator. And drain it that way you’re always going to want to pick the low hose at the bottom corner of the radiator.

How do you drain coolant without drain plug?

In general, the easiest way to drain coolant from systems like these is to disconnect the lowest fitting between the coolant hose and the engine block and let the coolant just drain out. Usually, it’s near the bottom of the block itself, so it shouldn’t be hard to reach from underneath the vehicle.

How do you completely drain coolant?

1. STEP 1 – Safety first.
2. STEP 2 – Press down on the radiator cap, slowly turn it counter-clockwise until it hisses, wait until the.
3. STEP 3 – Place a large container under the drain valve at the bottom of the radiator.
4. STEP 4 – Loosen the drain valve and allow the coolant to completely drain out.

How do I drain my VE Commodore coolant?

Starts here7:33Penrite Coolant Flush Fail – VE Calais V8 (Pontiac G8) – YouTubeYouTube

Can I use tap water to flush radiator?

You can use tap water, no problem. I recommend flushing the system as best you can with the hose, by pulling the right bottom hose off. Flush out as best as you can. Put the hose back on and fill the radiator.

Does the car need to be running when adding coolant?

Make sure your engine is off and cool, the vehicle is in Park or Neutral, and the parking brake is set. Open the hood and locate the engine coolant reservoir.

Where is the radiator cap on a VE Commodore?

Under the engine cover there is a hidden cap.

How many Litres of coolant does a VE Commodore take?

Note, not all of the coolant in the system will drain out. The book says the system holds 11 Litres. The radiator holds just under 6 Liters, the reservoir holds about 1.5 Liters and the block retains the remaining 3 to 4 liters. This need to be flushed out.

How to replace radiator drainage plug?

How to Replace Radiator Drainage Plug – Stop the Leak! 1 Place bucket below drain 2 Apply pressure to innards of the drain plug 3 Twist out plug 4 Collect coolant 5 Twist in new plug 6 Enjoy

How do you flush the radiator?

Take it easy or loose knuckle skin. D/c thermostat housing bottom radiator hose, radiator cap, stick a hose and go for it, even the to and fro to the heater core make sure it’s turned to hot and flush away, don’t use any supercheap or repco radiator flush on commodores it’s just not right nor needed. Keep flushing till water runs clear.

How do you fill up the radiator?

(Don’t forget to do up whatever you disconnected) leave cap off and undo bleeder (top of thermostat housing) turn heater on fully) start engine and fill at same time Even if the block has left in it from flushing adjust your radiator coolant mixture to allow.