What is stick scaling?

What is stick scaling?

Scaling Stick. Scaling Stick. A third method, and the most common, is to use a scaling stick. This is a piece of wood (about 1/4 inch thick and 1-1/2 inches wide) that has the footage numbers printed on the stick. The numbers are located on the stick at the spot that represents the diameter for that number.

How do you calibrate a drone motor?

The autopilot is now in ESC calibration mode….

1. Ensure your transmitter’s flight mode switch is set to “Stabilize Mode”.
2. Arm your Drone.
3. Give a small amount of throttle. All motors should spin at about the same speed and they should start at the same time.
4. Disarm your drone.

How do you read a log scale stick?

Read the scale stick directly from the end of the log, not obliquely from the side. → The diameter of a log is always measured inside the bark. This measurement is called “diameter inside of bark” or d.i.b. Use a log scale stick to measure the d.i.b. at the small end of the log.

How do I program the kk2 to my Spektrum DX7?

* I reset a current model in my Spektrum DX7, Reversed AILE and ELEV, selected Arco mode then bound to the receiver. Step 2: Mount the KK2.0 onto your Quad. The arrow on the bottom of the board goes towards the front of the quad. The buttons will be on the back of the quad so you will need to turn it around to see the LCD screen and program it.

How do I program the kk2 to the Quad?

The arrow on the bottom of the board goes towards the front of the quad. The buttons will be on the back of the quad so you will need to turn it around to see the LCD screen and program it. Do not use metal hardware to mount the KK2. It may short out the PCB tracks on the KK2 and ruin it.

What is the % on transtransmitter Expo for kk2?

Transmitter EXPO: 30% on everything Content: 00:18 – Hooking up the KK2 board 01:34 – 3 wire hookup 02:12 – Powering the KK2 board 03:00 – Hooking up the KK2 MINI 06:00 – Receiver test menu 08:45 – Loading a motor layout 10:15 – Reversing the Servo – increasing frame-rate 11:40 – MPU6050 setup 12:47 – ACC calibration 14:00 – Misc settings

Can I use metal hardware to mount the kk2?

Do not use metal hardware to mount the KK2. It may short out the PCB tracks on the KK2 and ruin it. Use nylon hardware. I made a plastic plate and used double sided tape to secure the FC.