What is the default Cisco switch password?

What is the default Cisco switch password?

admin
Most routers and switches by Cisco have default passwords of admin or cisco, and default IP addresses of 192.168. 1.1 or 192.168. 1.254. However, some differ as shown in the table below.

How do you reset a 2950 switch?

Reset a switch running Cisco IOS Software to factory defaults

1. Enter “enable” mode by typing:
2. The console prompt should change from “switch>” to “switch#” to signify this.
3. To reset the switch to factory default, issue the erase startup-config or write erase command.

How do I reset my Cisco 2960 console password?

To reset your Cisco 2960 password, connect your console cable to the switch and open up your terminal emulator software, you can use minicom if you are using Linux. Power on the switch while holding the mode button. Release the mode button after you see the screen below in your terminal emulator software.

How do I find my Cisco router password?

The default password of Cisco routers usually is either “admin”, “cisco” or the field is simply left blank.

How do you reset a network switch?

For instructions, follow the steps below:

1. Access the web interface of your switch.
2. Click on the Reset option located at the upper-right corner of the web interface.
3. Click OK.
4. Access the web interface of your switch.
5. Click on the Reboot option located at the upper-right corner of the web interface.
6. Click OK.

How do I change my Cisco router password?

Cisco 3848V change password

1. Visit the Admin Console by visiting 192.168.
2. Log in with the following information:
3. Click Login.
4. Click Wireless at the top of the page.
5. Click the Wireless Security tab.
6. Under 2.4GHz Wireless Security, type a new password for the network in the Pre-Shared Key field.